CK‐RX65N_Specification
| # | Item | Change type | Content | V1 baseboard [P/N:RTK5CK65N0S04000BE] Cellular Cloud Kit (RYZ014A Pmod) |
V2 baseboard [P/N:RTK5CK65N0S08001BE] Wi-Fi Cloud Kit (US159-DA16600EVZ Pmod) |
|---|---|---|---|---|---|
| 1 | PMOD I/F | Changed | IRQ of PMOD | Connect as IRQ | Connect as IRQ-DS (it can be used for Wake-up) |
| 2 | PMOD I/F | Changed | Change default setting on PMOD to full flow control. 1. UART with full flow control. 2. I2C. 3. SPI. |
Default: SPI/Control by either CTS or RTS for UART | Default: UART with full flow control |
| 3 | PMOD I/F | Added | UART full flow control (CTS & RTS) on Pmods | Not supported (either CTS or RTS) |
Supported (it can ed changed by a jumper) |
| 4 | IIC I/F | Changed | Sensor Connection to RX65N | Sensors connect to 1 channel of IIC. All sensors are conneted to channel 0. |
Sensors connect to 3 channels of IIC. Channel 0: HS3001, ICM-42605, and ICP-20100 Channel 1: ZMOD4510, and ZMOD4410 Channel 12: OB1203 |
| 5 | IIC I/F | Added | IIC test pad (for waveform confirmation) | N/A | Supported |
| 6 | USB Serial Converter IC | Changed | USB to Serial conversion | RL78/G1C | FTDI (Improved throughput due to dropouts) |
| 7 | Sensor IC | Changed | Motion Tracking sensor | TDK 9-axis sensor (EOL) | 6-axis sensor |
| 8 | Sensor IC | Changed | Barometric pressure sensor | ICP-10101 | ICP-20100 w/o level shifter |
| 9 | ADC | Added | Fix short on both motion and pressure sensor on AD0 pin. Connecting pin to GND gives the desired address. |
N/A | Put a resister to DNF to allow users to fit to enable if needed. |
| 10 | USB | Changed | USB connecor type for USB Serial Converter | USB micro B | USB C |
| 11 | Ether | Added | Added resistors and capacitors on Ethernet pins (TP_AP, TP_AN, TP_BP, TP_BN) | N/A | Four 9.9ohm resistors and two 100nF caps to Ethernet connection |
| 12 | Ether | Changed | RX65N GPIO port# to connect the P0/LED0 pin(for Link Status) of EtherPHY | P54 port of RX65N | PA5 port of RX65N |
| 13 | Sub Clock capacitor | Changed | Changed capacitor for X2(Sub Clock) | 27pF | 15pF |
| 14 | Power Supply | Added | Power Supply from VBUS of the USB Serial Converter IC | It does NOT connect the VBUS power supply from USB/SCI to the MCU line | Connect the VBUS power line from the USB Serial Converter IC |
| 15 | Others | Changed | LED2, S2, ISL8002 | Power-good output of ISL8002 is not supported | Power-good output of ISL8002 is supported. Change pin assignment |
