Get Started
Home | Installation Guide | Get Started | Developer Resources | BEMOSS™ Team| FAQ
The detail about devices supported by BEMOSS™ 3.5 can be found here.
1. HVAC Load Controllers
2. Lighting Load Controllers
3. Plug Load Controllers
4. Sensors
- If you have not installed BEMOSS™, please follow the installation instruction here.
- If you would like to use more than one BEMOSS nodes, please follow the instruction to configure the multi-node system here.
- If you need Email notifications, please follow the instruction for Email configuration here.
- If you need a weather service, please follow the instruction on this page to set up the weather service.
Now, please start the BEMOSS™ Launcher Wizard by following Step 1 here.
- If you have not already configured your PostgreSQL database settings during installation, please configure it by clicking here
Click Run BEMOSS on the BEMOSS™ Launcher Wizard.
Wait until a new Terminal window shows up, as shown below:
This means your BEMOSS™ has been started.
Make sure you have configured a multi-node system. Make sure you have an already running BEMOSS™ core in the same network. On the computer where the BEMOSS™ node is running, click Run BEMOSS on the BEMOSS™ Launcher Wizard.
After BEMOSS™ is started, you can use BEMOSS™ WEB UI to approve discovered device, control devices, set schedule and so on.
A detailed user guide for BEMOSS™ WEB UI can be found HERE
Encounter problems? Please visit our FAQ page.
Still have problem? Please email us at [email protected].