stts22h-rs

Provides a platform-agnostic, no_std-compatible driver for the ST STTS22H temperature sensor, supporting both I2C and SPI communication interfaces.

Sensor Overview

The STTS22H is a digital temperature sensor that communicates over a 2-wire I²C/SMBus 3.0 serial interface. Thanks to its factory calibration, the STTS22H offers high-end accuracy performance over the entire operating temperature range reaching as low as ±0.5 °C without requiring any further calibration at the application level.

The sensor operating mode is user-configurable and allows selecting between different ODRs (down to 1 Hz) or the one-shot mode for battery saving. In one-shot mode, the sensor current consumption falls to 1.75 µA.

The STTS22H comes in a 6-pin device that supports user-configurable slave addresses. By connecting properly the Addr pin (see Table 2), four different addresses can be specified, thus allowing to have up to four STTS22H sharing the same I²C/SMBus bus line. An interrupt pin is also available to signal the application whenever the user-selectable high or low threshold has been exceeded.

For more info, please visit the device page at https://www.st.com/en/mems-and-sensors/stts22h.html

Installation

Add the driver to your Cargo.toml dependencies:

[dependencies]
stts22h-rs = "0.1.0"

Or, add it directly from the terminal:

cargo add stts22h-rs

Usage

Include the crate and its prelude

use stts22h_rs as stts22h;
use stts22h::*;
use stts22h::prelude::*;

Create an instance

Create an instance of the driver with the new_<bus> associated function, by passing an I2C (embedded_hal::i2c::I2c) instance and I2C address, or an SPI (embedded_hal::spi::SpiDevice) instance.

An example with I2C:

let mut sensor = Stts22h::new_i2c(i2c, I2CAddress::I2cAddH).unwrap();

Check "Who Am I" Register

This step ensures correct communication with the sensor. It returns a unique ID to verify the sensor's identity.

let whoami = sensor.dev_id_get().unwrap();
if whoami != ID {
    panic!("Invalid sensor ID");
}

Configure

See details in specific examples; the following are common api calls:

// Set Output Data Rate
sensor.temp_data_rate_set(OdrTemp::Odr1Hz).unwrap();

License

Distributed under the BSD-3 Clause license.

More Information: http://www.st.com.

Copyright (C) 2025 STMicroelectronics