Skip to content
New issue

Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.

Sign up for GitHub

By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.

Already on GitHub? Sign in to your account

Jump to bottom

laser cut TODO #3

Open
zumdar opened this issue Apr 2, 2021 · 8 comments
Open

laser cut TODO #3

zumdar opened this issue Apr 2, 2021 · 8 comments

Comments

@zumdar
Copy link
Owner

zumdar commented Apr 2, 2021

make hole mount for servo
add top mounting holes for pcb
add hole for button
holes for pots
@zumdar
Copy link
Owner Author

zumdar commented Apr 5, 2021 •
edited
Loading

back panel:
10.75mm diameter dc in

19.5mm diameter switch w/ 2mm notch on 1 side

could i route out a channel on the back so the entire back panel could slide off?

@zumdar
Copy link
Owner Author

zumdar commented Apr 5, 2021

mg90s servo look for design file online

@zumdar
Copy link
Owner Author

zumdar commented Apr 5, 2021

mic mounting hole - 10mm

@zumdar
Copy link
Owner Author

zumdar commented Apr 5, 2021

mounting holes for arduino

@zumdar
Copy link
Owner Author

zumdar commented Apr 5, 2021

penduluum arm, stepper motor arm

@zumdar
Copy link
Owner Author

zumdar commented Apr 7, 2021

get switch cap and measure
make sure filter knob will fit 8mm hole

screws and standoffs
4x M3 - arduino
4x M3 - ext to clock face
2x M3 user interface
2x M3 - voltage converter
standoffs for the clock face

@zumdar
Copy link
Owner Author

zumdar commented Apr 7, 2021

  • nuts and washers for pots

@zumdar
Copy link
Owner Author

zumdar commented Apr 7, 2021

  • nuts and washer for switch

Sign up for free to join this conversation on GitHub. Already have an account? Sign in to comment
Assignees
No one assigned
Labels
None yet
Projects
None yet
Milestone
No milestone
Development

No branches or pull requests
1 participant
@zumdar