Skip to content

README.md

Latest commit

 

History

History
99 lines (64 loc) · 2.39 KB

README.md

File metadata and controls

99 lines (64 loc) · 2.39 KB

BrewBlox Deployment

This repository contains integration tests for BrewBlox, and example configurations for getting started.

Getting Started

Requirements

  • Desktop / laptop computer
  • Raspberry Pi or Linux desktop computer / laptop
  • BrewPi Spark controller
  • Git
  • Docker
  • Docker-compose

Firmware

Note: While the services can be run on a Raspberry Pi, building and flashing the firmware must be done on an AMD64 / x86_64 system.

Clone the firmware repository

In your terminal, run

git clone https://github.com/BrewPi/firmware.git
cd firmware
git checkout feature/brewblox
cd docker

Put the Spark in DFU mode

  • Connect the spark to your computer using the usb cable
  • Unplug the spark usb cable
  • There are two sunken buttons on the right side of the spark. Press and hold the top one (you'll need something pointy)
  • Reconnect the usb cable while still holding the button
  • Release the button: the led light should be blinking purple

Flash the firmware

In your terminal (still in the firmware/docker directory), run

docker-compose up -d compiler
docker-compose exec compiler bash compile-proto.sh
sudo docker-compose exec compiler make APP=brewblox PLATFORM=p1 program-dfu

Services

Clone the deployment repository

In your terminal, run

git clone https://github.com/BrewBlox/brewblox-deployment.git

Select a configuration

There are two sets of configurations available: amd64, and armhf.

If you're installing BrewBlox on a desktop computer, choose brewblox-deployment/amd64.
If you're installing Brewblox on a Raspberry Pi, choose brewblox-deployment/armhf.

Set Spark address

If you're connecting through USB, you do not need to make any changes. The Spark Service will autodetect the controller.

If you're connecting to a Spark Controller using WiFi, you must add its IP address to the configuration. In your configuration's directory, open docker-compose.yml, and edit the following lines:

    # command: >
    #   --device-host=192.168.0.2

Remove the # to uncomment, and replace 192.168.0.2 with the IP address of your Spark Controller.

Install

In your terminal, navigate to your chosen configuration, and run

docker-compose pull

This may take a few minutes.

Start

In your terminal, run

docker-compose up -d

In your browser, visit the IP address of your computer or Raspberry Pi to open the UI.