PR Push to Test environment #2132
-
|
Good day, We are trying to push a PR to an environment, however we are getting the below error, 
The below is the setup in AL-GO 
Any advice would be appreciated. Regards |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 5 replies
-
|
It seems the |
Beta Was this translation helpful? Give feedback.
-
|
Attached the logs Yes this is from the main-support branch |
Beta Was this translation helpful? Give feedback.
-
|
It seems the logs are from another run, because the environment is correctly picked up. The issue from the logs is during deployment: the latest PR Build on the pull request appears to have failed. In that case AL-Go will not try to publish to an environment as there might not even be artifacts to publish. |
Beta Was this translation helpful? Give feedback.
-
|
Yes, the artificats on the PR is not being built. Where can I check that the coonfiguration is correct for making sure the PR does indeed build the artifacts? |
Beta Was this translation helpful? Give feedback.
-
|
The latest "Pull Request Build" run on that PR. It should be accessible either from the PR itself, or by going to Actions => Pull Request Build and then looking for a run on the PR number or the PR branch. E.g. |
Beta Was this translation helpful? Give feedback.
-
|
Thanks, Resolved |
Beta Was this translation helpful? Give feedback.
The latest "Pull Request Build" run on that PR.
It should be accessible either from the PR itself, or by going to Actions => Pull Request Build and then looking for a run on the PR number or the PR branch. E.g.