Dynamic Power Limiter (Nulleinspeisung) – OHNE BATTERIE
Enable the switch "Inverter is powered by solar modules" in the DPL settings:
Other DPL settings (those that are still presented when this switch is enabled), apply to all systems and are described in the parent page.
If you had already set the parameters for "operation without a battery" with previous Firmaware versions and set the threshold values for battery utilisation to 0 or 1
In newer Firmware versions, you only need to enable the "Inverter is powered by solar modules" switch.
If this is activated, the input masks for the threshold values are deactivated.
However, 0 and 1 were still the values here, but the minimum value is now specified as 16.
Currently, there is no error message if the values (not displayed) are incorrect.
The situation however may cause the inverter to switch off.
If you experience such a situation, please proceed with the following steps:
- Disable "operation without a battery"
- Check the threshold values and correcting the values to 16
- Save your settings
- Enable "operation without a battery" again
- Save your settings
The inverter should no longer turn off