Hello, and first off thanks so much for sharing this! I couldn't believe it wasn't the stock behavior.
I have to admit, I've changed two things simultaneously, so I can't be 100% certain of what is going on. I updated my firmware to the latest 01.05.02.00 (01.05.01.00 worked great for me), and I also installed a new 0.2mm nozzle.
Now, the flush takes several minutes to complete, and the extrusion is very slow. Performing a manual "Load" action is much faster. Combined with the door being open, it makes quite a stringy mess.
After I'm finished using the 0.2mm nozzle I'll swap back and check again with the 0.4 to confirm whether it was the firmware update that caused this, or the nozzle size (or both I suppose).
Hello, and first off thanks so much for sharing this! I couldn't believe it wasn't the stock behavior.
I have to admit, I've changed two things simultaneously, so I can't be 100% certain of what is going on. I updated my firmware to the latest 01.05.02.00 (01.05.01.00 worked great for me), and I also installed a new 0.2mm nozzle.
Now, the flush takes several minutes to complete, and the extrusion is very slow. Performing a manual "Load" action is much faster. Combined with the door being open, it makes quite a stringy mess.
After I'm finished using the 0.2mm nozzle I'll swap back and check again with the 0.4 to confirm whether it was the firmware update that caused this, or the nozzle size (or both I suppose).