Zigbee DC electrical measurement sensor, are not dicovered by HA

[tvixen]

I want to build a "Zigbee DC electrical measurement sensor" for my Solar panel and battery.
Both input and output in the same ESP32-C6 chip. So I started testing the example in the Arduino Zigbee library:
Zigbee DC electrical measurement sensor.ino

It compile fine and in the serial Monitor, it is sending volt, current and power. Everything looks fine...
But when connected to HA, it will only show up as "Identify" :

... I was expecting Volt, Current and Power like any other measuring sensor... like this:

But instead i looks like this:

It apparently does not transmit the 3 sensors...
Is there anything wrong with the example code, or am I using this Arduino code totally wrong, or looking at it from a wrong "angle" ? 🤷‍♂️

[tvixen]

Yep ... Still sending these values via ZigBee to HA....

AC values is reported in the other end.... question is, why AC and not DC?
Is it an error in the example, or an error in HA?

Ps. The AC sketch is working as a charm.

[tvixen]

Hello @P-R-O-C-H-Y
Any chance you can comment on why its reporting AC values and not DC values?

[P-R-O-C-H-Y]

This needs to be merged in ZHA in order to add DC measurement support zigpy/zha#453

Still pending...

[tvixen]

ok thanks for letting me know about this issue.
Pls. let me know if I can be in any help at all, to solve this.

[tvixen]

Would be a great help if this sensor could produce the wanted measures from HA: