Enable HDMI video signal before turning the sources on

[redddcyclone]

Hello there.

I don't know if this is feasible, and it's not exactly an issue, just something I'd like to have...

When I turn on the GBS-C Pro, no video is sent via HDMI until a video source (e.g. a console) is turned on. Even so, it takes a long time for the TV to show something (depending on the TV). This often causes intros to be skipped. If I then turn the source off, a black screen (sometimes with some "remains" of the last shown image) stays there, and after this, if I turn on the source again, I can see the intros normally.

If I remember correctly, if I enter the OSD menu from power on without turning a source on, the video signal comes up and a black screen stays there even when I close the menu, and this also allow the intros to be seen. I'm not too sure though, as I can't test right now...

So, is it possible to make the GBS-C Pro always output video from power on (a black screen maybe or something else?) without waiting for a source to come up?

Thanks a lot!

[warheat1990]

Yeah I would love this feature as it took a while to get a signal (unless you spam OSD)

[Killertamagotchi]

The problem is that the GBS-C selects the preset or resolution depending on the signal being fed in.

In theory, one could say that it uses the settings from the last preset until a different signal comes in, but this still results in a certain time lag between switching.

[20-Percent-Cooler]

for the GBS C Pro. don't forget the composite and S video are sending in a blank screen over component input side. so the GBS C pro might need a moment to swap over to the RGB side if your source is RGB