I successfully compiled and installed the software on an esp32 wroom and when i upload the html file the webserver dashboard showed. When i connect the nice!nano with the pads on the back i can "as it seems" init sw and al the parameters of the board are shown. I can erase and i can upload but whatever i do no bootloader gets installed . It is not clear to me if i should use hex or bin files and where to put them selecting a file and then select flash turns in a endless loop on the webpage. When i upload a file to the edit page and then select it in the webpage, it seems to sart uploadingand it says it is finised but never a disk shows when hitting reset twice any explaination would be greatly appreciated
I successfully compiled and installed the software on an esp32 wroom and when i upload the html file the webserver dashboard showed. When i connect the nice!nano with the pads on the back i can "as it seems" init sw and al the parameters of the board are shown. I can erase and i can upload but whatever i do no bootloader gets installed . It is not clear to me if i should use hex or bin files and where to put them selecting a file and then select flash turns in a endless loop on the webpage. When i upload a file to the edit page and then select it in the webpage, it seems to sart uploadingand it says it is finised but never a disk shows when hitting reset twice any explaination would be greatly appreciated