You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
After adding the Qidi profiles to Cura, I was able to get Qidi print to work with my printer. I loaded a file and attempted to slice it. I got an error saying I am unable to slice due to z hop speed. When I go to that setting, it has 10mm/s filled in but highlighted red. If I change value to 5 or less, the red highlight goes away but still receive same error. In addition, the generic materials now all show an error that says "there are no profiles matching the configuration of this extruder" and it says empty next to print core in extruder drop down
S
The text was updated successfully, but these errors were encountered:
After adding the Qidi profiles to Cura, I was able to get Qidi print to work with my printer. I loaded a file and attempted to slice it. I got an error saying I am unable to slice due to z hop speed. When I go to that setting, it has 10mm/s filled in but highlighted red. If I change value to 5 or less, the red highlight goes away but still receive same error. In addition, the generic materials now all show an error that says "there are no profiles matching the configuration of this extruder" and it says empty next to print core in extruder drop down
S
The text was updated successfully, but these errors were encountered: