Some parts don't scale correctly in career mode under KSP 1.9.x, PP 2.0.6

[Lafreakshow]

I've noticed this with the separater and the nose cone. If I'm unsterstanding correctly, the former should have an upper limit for the diameter of 1.75m with Engineering 101 unlocked but the actual upper limit is somewhere around 0.3m at that point. The latter has it's maximum height limited to 0.001m. Naturally, both parts also have the wrong default size, as it exceeds the limits. In both cases these limits also seem to change arbitrarily by a couple cm when changing the shape of the part, I guess this could be because they have their maximum volume limited as well, which would then also way too low. Nothing unusual to be seen in the KSP or Module Manager logs. Judging from the Module Manager cache, the parts have the correct limits set.

These issues don't happen in sandbox mode. So far I've only tested this with the first couple tech nodes unlocked (including Engineering 101 and stability). I have these issues in my 200+ mod install (including Community Tech Tree) and in a clean install with only PP installed. I will probably test this with a bunch of different combinations of unlocked tech nodes in the coming days and report back with the result.

Note that the Heatshield may have similar issues, it's limits seemed too low to me. But I haven't looked into that particular part further.