LDT tile dimension not matching

[Arijit22IITDelhi]

Hello, I was trying to run LDT for ensemble generation (from 1 to 20). The input restart file that I am using contains "ntiles: 71720". But after running the LDT config file with almost all the necessary specifications, it is showing an error as per the LDT log entry below:

• • • • • • • • • Noah-MP Parameters - - - - - - - - - - - -
                  Total number of surface tiles: 71623
                  Total number of tiles for LSM: 71623
                  Total number of grid points: 71623
                  Generating restart file: ./OUTPUT/LIS_EnRST_JOINT_DA_Trial.nc
                  [ERR] The tile dimension in the input restart file
                  does not match the tile dimension computed in LDT.
                  endrun is being called

How do match the number of tiles for both? I am sharing the corresponding LDT config file and the error log file for reference.

ldt_enrst.txt
ldtlog_Enrst.txt

[MariRiba]

Hi
I also encountered similar error before. And I solved it by matching the config file for ensemble-restart and config file for input restart . Can you provide config file that generated the input restart file ?

[Arijit22IITDelhi]

@MariRiba sure, here is the lis.config file, from which I generated the corresponding input restart file for LDT-ensemble restart:

LIS_MERRA2.txt

[MariRiba]

Sorry, @Arijit22IITDelhi
The lis_input***.nc file is generated by the ldt.config . You might have mismatch in that file and ensemble restart config.
Can you provide that file too?

[Arijit22IITDelhi]

Ok, now I have the reason, the issue got resolved. Thank you, @MariRiba.

[Shuzunyun]

Ok, now I have the reason, the issue got resolved. Thank you, @MariRiba.

Hi, how did you solve this problem? I encountered the same problem as you did.