Repository navigation
|
First, thank you for your work on this! I am currently building a few of these boards (after getting them from JLCPCB) and eventually I would like to attach a GPS unit to the serial pins on the board. Is there a pinout as to which pin is what for the 4 serial pins? I am sure I can dig it out from the gerber file but I was curious if it is listed somewhere else. |
Answered by
HefnySco
Nov 1, 2021
Replies: 1 comment 1 reply
|
Hi, the four pins named serial in the bottom if the following image.
connections are [RX,TX,GND,5V] from left to right. Remember to connect RX<---> TX of GPS and vice versa.
You need to run ardupilot file with -B /dev/serial0 |
1 reply
|
Fantastic! Thank you for the assistance and in an amazingly quick reply! I appreciate it greatly. |
Answer selected by
pghpete
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
Hi,
the four pins named serial in the bottom if the following image.
connections are [RX,TX,GND,5V] from left to right. Remember to connect RX<---> TX of GPS and vice versa.
You need to run ardupilot file with -B /dev/serial0