The timer values for antline magnet indicator boxes is almost illegible, instead use a icon to show the orientation

[Potato-Man1234]

Description of the feature

A symbol that were to show this side up like seen on packaging

Instead of the timer values around the square on which the indicator sits to help see what orientation your signs at on 1080p displays on farther ends of your chamber

Why should this be implemented

Multiple times while using antline magnets I run it the problem where the timer values on the indicator panel part of the antline magnet is almost impossible to make out due to the poor contrast and how small the numbers are to the point I constantly place them the wrong way around. By using this it would be much easier to determine the orientations of the signage

Additional information

No response

[TeamSpen210]

Not sure how a this-way-up icon would work here. Probably should make the numbers much bigger, they are quite small. But the checkmark itself has an orientation, so you should be able to double-check by looking at that. That's why it shows a check not a cross.

[Potato-Man1234]

Not sure how a this-way-up icon would work here. Probably should make the numbers much bigger, they are quite small. But the checkmark itself has an orientation, so you should be able to double-check by looking at that. That's why it shows a check not a cross.

Uhh it might of not been packaged properly as its just a white square for me

[TeamSpen210]

Ah right I failed to include those materials.