The MP4 is the user's original Wokwi demonstration, copied without transcoding. The PNG preview is a frame at approximately 10 seconds. In that frame, the beginner sketch is visible, the LCD shows Need the toilet, and Serial Monitor lists Yes, No, Water, Food and Toilet messages. The GIF is a smaller animated derivative of the same recording. These are simulation visuals, not photographs of physical hardware.
- The beginner sketch was compiled as C++ using mocked Arduino, Serial and LCD interfaces.
- Assertions passed for all six phrase mappings, held-input single firing, Repeat, Clear, Repeat after Clear, simultaneous-input rejection and release-to-rearm.
- Repository media paths, diagram JSON, code-to-circuit pin mapping and archive integrity were checked.
- The original video copy was checked byte-for-byte.
The mock harness checks program logic, not real Arduino timing, debounce waveforms, buzzer sound or electrical behavior. A fresh Wokwi/AVR compilation was not performed during this packaging step. The included user recording supplies the visual Wokwi demonstration of the beginner version. Physical touch modules and accessibility/usability have not been tested.
- Load the three Wokwi files following README.md and start the simulation.
- Wait for
TouchTalk readyand release all buttons. - Test 1–6 against the message table.
- Hold an input: there should be one message until all inputs are released.
- Repeat after a phrase: the same phrase should appear again.
- Clear, then Repeat:
No message yetshould appear. - Activate two inputs together before either is accepted: an instruction to use one pad should appear. Release all before retrying.
- Confirm the display and Serial Monitor match and check that browser audio permits the buzzer.
The two-sample 40 ms debounce is deliberately basic. It may miss brief presses or changes between samples and does not provide guaranteed rejection of all noisy signals.