Hello. I am trying to get the echo example working and not getting very far. First, I had to add a reset command before the advertising parameters were set, otherwise I would only see Command Disallowed.
Now, I can get my client (nRF Connect) to connect for a couple seconds, but then it reports Connection terminated by peer (status 19). btmon shows this:
< HCI Command: Disconnect (0x01|0x0006) plen 3 #74 [hci0] 12.531595
Handle: 3585
Reason: Remote User Terminated Connection (0x13)
> HCI Event: Command Status (0x0f) plen 4 #75 [hci0] 12.650524
Disconnect (0x01|0x0006) ncmd 1
Status: Success (0x00)
> HCI Event: Disconnect Complete (0x05) plen 4 #76 [hci0] 12.802713
Status: Success (0x00)
Handle: 3585
Reason: Connection Terminated By Local Host (0x16)
@ MGMT Event: Device Disconnected (0x000c) plen 8 {0x0001} [hci0] 12.802768
LE Address: 4A:72:79:52:67:9C (Resolvable)
Reason: Connection terminated by local host (0x02)
< HCI Command: LE Set Extended Advertising Param.. (0x08|0x0036) plen 25 #77 [hci0] 12.843583
Handle: 0x00
Properties: 0x0013
Connectable
Scannable
Use legacy advertising PDUs: ADV_IND
Min advertising interval: 1280.000 msec (0x0800)
Max advertising interval: 1280.000 msec (0x0800)
Channel map: 37, 38, 39 (0x07)
Own address type: Public (0x00)
Peer address type: Public (0x00)
Peer address: 00:00:00:00:00:00 (OUI 00-00-00)
Filter policy: Allow Scan Request from Any, Allow Connect Request from Any (0x00)
TX power: 127 dbm (0x7f)
Primary PHY: LE 1M (0x01)
Secondary max skip: 0x00
Secondary PHY: LE 1M (0x01)
SID: 0x00
Scan request notifications: Disabled (0x00)
> HCI Event: Command Complete (0x0e) plen 5 #78 [hci0] 12.844460
LE Set Extended Advertising Parameters (0x08|0x0036) ncmd 1
Status: Command Disallowed (0x0c)
TX power (selected): 48 dbm (0x30)
The Disconnect and LE Set Extended Advertising Parameters commands do not seem to be coming from pybleno. But there is nothing else on the system talking with bluetooth (i.e. no bluetoothd).
Might be related: noble/noble#242
The full btmon log is as here:
btmon.log
Hello. I am trying to get the echo example working and not getting very far. First, I had to add a reset command before the advertising parameters were set, otherwise I would only see
Command Disallowed.Now, I can get my client (nRF Connect) to connect for a couple seconds, but then it reports Connection terminated by peer (status 19). btmon shows this:
The
DisconnectandLE Set Extended Advertising Parameterscommands do not seem to be coming from pybleno. But there is nothing else on the system talking with bluetooth (i.e. no bluetoothd).Might be related: noble/noble#242
The full btmon log is as here:
btmon.log